Improved call clarity in busy or windy areas.
Use only one earphone (Single Earbud Mode)
The two headphones can be used alone as a Bluetooth hands-free kit.
Support for voice assistant
Triple-tap one of the earbuds to access your phone’s assistant.
A sensitive and tactile panel on each earbud allows easy music control and call management.
The ultra-compact charging case protects your headphones and holds 4 additional charges.
Model: Aukey EP-T25
Technology: BT 5, A2DP, AVRCP, HFP, HSP, AAC
Driver (each channel): 1 x 6mm / 0.24” speaker driver
Sensitivity: 90 ±3dB SPL (at 1kHz/1mW)
Frequency Range: 20Hz – 20kHz
Impedance: 16 ohm ±15%
Microphone Type: MEMS (microphone chip)
Microphone Sensitivity: -38dB ±1dB (at 1kHz)
Frequency Range Microphone: 100Hz – 10kHz
Charging Time: 1 Hour
Battery Life: Up to 5 hours
Battery Type: Li-polymer (2 x 40mAh)
Operating Range:10m / 33ft
IP Rating: IPX5
Weight: 7g (pair)
1 x Aukey EP-T25 TWS Earbuds
1 x Charging Case
3 pairs of earTips (S/M/L)
1 x USB-A to USB-C charging cable
1 x User manual
Q1: Why there is a film between the charging pins and earbuds? Should I remove it?
A: Yes. The film is used to prevent the battery from running out during the shipping process. Please remove that film and return the earbuds to the case. And then you can open the lid again and the earbuds will enter pairing mode.
Q2: I already put my earbuds in the charging case, why they are still connected to my phone?
A: Please make sure to close the lid if you want to turn off the earbud or disconnect form your phone. The earbuds will only automatically turn off when they were put back to the charging case and the lid is closed.
Q3: Why only one of my earbuds is working? How should I reset the earbuds?
A: Try return both earbuds to the charging case and put on them again. If the problem still exists, just touch and hold the touch sensitive panel on both earbuds for 10 seconds to clear the pairing list, and then follow the user manual to pair your device again. (*Note : Sometimes the earbud may turn off for insufficient battery, you should return it to the case to charge. It’s better to charge the case when the LED indicator shows with 1 grid of the battery.)